Pressuryte info
 

Pressuryte is a pressure based ride height system that has some serious advantages over other pressure based ride height systems. Some of the main advantages are as follows:

Cost ($349.99 compared to over $500.00 most other units are)

size (Pressuryte measures 4.5" wide, 3" deep and 4" tall, very compact.)

Ease of install (Pressuryte can be installed in 15 minutes in ideal situations and in about an hour or so most of the time, other systems can take an entire weekend to install, it is designed to be installed on an existing air suspension setup as a "piggyback" automatic ride height system, in other words if you turn it off your system works EXACTLY as it did before the Pressuryte was installed. The four 1/8" lines are hooked up exactly like gauge lines (you can even T these into your gauge lines), a 1/4" supply line from your tank and wire up the on/off switch, it's that easy)

Works with ANY size valves (because the Pressuryte system does not use your current valves to lift and lower your vehicle to ride height it can be installed on vehicles with any size valves and be completely accurate, other systems try to overcome this by “pulsing” your existing "fast" valves which is just not accurate and lowers the life of your valves)

It is not intrusive (there are no control units or displays that have to be installed in the cab area of your vehicle, the only thing you install in the cab area is an on/off switch)

It’s always active (when the unit is turned on it is ON unlike most other units that are only active for the first 30 seconds, if you have a small leak and you are on a long drive other units will not replenish the lost pressure, Pressuryte does).